Hard Disk Test Detail Status - Toshiba T3400 Maintenance Manual

3.15 Hard Disk Test Detail Status

When an error occurs in the hard disk test, the following message is displayed:
HDC status = XXXXXXXX
Detailed information about the hard disk test error is displayed on the screen by an eight-digit
number. The first four digits represent the hard disk controller (HDC) error status number,
the last four are not used.
HDC error status is composed of 2 bytes; the first byte displays the contents of the HDC
status register in hexadecimal form, the second displays the HDC error register.
The contents of the HDC status register and error register are described in Tables 3-4 and 3-
5, respectively.
Table 3-4 Hard Disk Controller Status Register Contents
Bit Name
7 BSY
(Busy)
6 DRDY
(Drive ready)
5 DWF
(Drive write fault)
4 DSC
(Drive seek
complete)
3 DRQ
(Data request)
2 CORR
(Corrected data)
1 IDX
(Index)
0 ERR
(Error)
3-34
Description
"0" --- HDC is busy.
"1" --- HDC is ready.
"0" --- Hard disk drive is not ready to accept any command.
"1" --- Hard disk drive is ready.
"0" --- DWF error is not detected.
"1" --- Write fault condition occurred.
"0" --- The hard disk drive heads are not settled over a track.
"1" --- The hard disk drive heads are settled over a track.
"0" --- Drive is not ready for data transfer.
"1" --- Drive is ready for data transfer.
"0" --- Other
"1" --- Correctable data error was corrected.
"0" --- Other
"1" --- Index is sensed.
"0" --- Other
"1" --- The previous command was terminated with some error.
T3400, T3400CT