4.13 Display Mask
Removal
To remove the display mask, follow the steps below and refer to Figure 4-22.
1.
Turn off the power to the computer and disconnect the AC adapter, power cord,
and all external cables.
2.
Remove the battery pack as described in section 4.2.
3.
Remove two screw covers from the display hinges and two rubber pads from the
top corners of the display (Figure 4-22).
4.
Remove two brass M2.5x6 screws at the bottom corners of the display mask, and
two brass M2x6 screws at the top corners (Figure 4-22).
5.
Slip your fingers between the display cover and mask and pull out gently to
release one latch at the top center.
6.
Continue around the display cover to release two more latches at the top, four
latches on each side and five latches at the bottom (Figure 4-22).
T3400, T3400CT
Figure 4-22 Removing the Display Mask
4-29