Configuring Remote Management - Cisco RV215W Administration Manual

Configuring the Firewall
Configuring Basic Firewall Settings
STEP 3
Cisco RV215W Wireless-N VPN Firewall Administration Guide
FTP ALG
Click Save.

Configuring Remote Management

You can enable remote management so you can access the device from a remote
WAN network.
To configure remote management, configure these settings on the Basic Settings
page:
Remote Management
Remote Access
Remote Upgrade
Allowed Remote IP
Address
Remote Management
Port
Click Auto to use the default FTP port 21. Click
Manual to enter the port number through which
you want to direct FTP traffic on the device.
Check Enable to enable remote management.
Choose the type of web access that can be used
to connect to the firewall: HTTP or HTTPS (secure
HTTP).
To allow remote upgrades of the device, check
Enable.
Click the Any IP Address button to allow remote
management from any IP address, or enter a
specific IP address in the address field.
Enter the port on which remote access is allowed.
The default port is 443. When remotely accessing
the router, you must enter the remote management
port as part of the IP address. For example:
https://<remote-ip>:<remote-port>, or
https://168.10.1.11:443
8
88