Fan & Cast Faceplate Installation - HAMPTON BAY HI200 Owners & Installation Manual

INSTALLATION
Enamel & Cast components are very fragile. Use extreme care when handling.
Note: The liner and fl ue adaptor should be installed prior to
reading these instructions.
1) With door already removed - place fan in front of unit as shown below,
Loosen 2 fl ange bolts - adjust fl ange to rest on fan assembly, once
height has been determined .
Leave 2" between fan and unit, tighten 2 fl ange bolts using 7/16"
open end wrench.
Fan assembly can now be secured to the unit using 2 bolts on both
left and right side - see Diagrams 1 & 2.
Diagram 1
Note: If screws do not lineup, loosen the 2 screws per side as shown in
Diagram 2 and adjust left side and right side facia. Tighten the 2 screws
per side and install the fan on the unit.
12
FAN & CAST FACEPLATE INSTALLATION
Diagram 2: Back View of
Fan Installation
Stop! Read Carefully.
2) Slide the unit into position leaving partially out to allow for installation
of the left and right side surrounds.
3) Install the left and right side surround to the mounting brackets on
the unit using 2 bolts per side. See Diagram 3.
Gasket
Mounting Bracket
4) Place a strip of gasket on top of the left and right side surround on
the front lip of the side castings. See Diagram 3.
5) Carefully slide the top surround in place by aligning the mounting
plates with the two retainers in the left and right side surrounds.
See Diagram 4.
Gasket
Mounting Bracket
Diagram 3
Diagram 4
HI200 Hampton Wood Cast Insert