JVC RX-9000VBK Instructions Manual page 66

PROBLEM
Continuous hiss or buzzing during FM
reception.
Occasional cracking noise during FM
reception.
No colors on the on-screen display.
Howling during record playing.
"OVERLOAD" starts flashing on the
display.
"TURN ON MAIN OR SUB ROOM"
appears on the display.
Remote control does not work.
64
POSSIBLE CAUSE
Incoming signal is too weak.
The station is too far away.
An incorrect antenna is used.
Antennas are not connected properly.
Ignition noise from automobiles.
The color system of the connected TV is
not NTSC.
Your turntable is too close to speakers.
Speakers are overloaded because of high
volume either in the main room or in the
sub-room.
Speakers are overloaded because of short
circuit of speaker terminals.
The receiver is turned on with the main
room and sub-room sounds deactivated.
The multi-room operation selector is not
set correctly.
The remote control mode selector is not
set correctly.
RF communication between the receiver
and the remote control is interrupted from
outside.
Batteries are weak.
SOLUTION
Connect an outdoor FM antenna or contact
your dealer.
Select a new station.
Check with your dealer to be sure you have
the correct antenna.
Check connections. Move the antenna farther
from automobile traffic.
Connect an NTSC TV.
Move speakers away from the turntable.
1. Press POWER on the front panel to turn off
the receiver.
2. Stop the playback source.
3. Turn on the receiver again, and adjust the
volume.
Press POWER on the front panel to turn off
the receiver, check the speaker wiring, then
press it again to turn on the receiver again.
If "OVERLOAD" does not disappear though
speaker wiring is not short-circuited, consult
your dealer.
• Press MAIN ROOM ON/OFF for the main
room operations.
• Press SUB ROOM ON/OFF for the sub-
room operations.
Set the selector correctly either to "MAIN
ROOM" or to "SUB ROOM."
Set the selector correctly either to "AUDIO/
TV/VCR" or to "CATV/DBS."
Consult your dealer.
Replace batteries.