Av Compu Link Remote Control System - JVC RX-9000VBK Instructions Manual

AV COMPU LINK Remote Control System

The AV COMPU LINK remote control system allows you to operate JVC video components (TV, VCR, and DVD player)
through the receiver.
To use this remote control system, you need to connect the video components you want to operate, following the
procedure below.
1. If you have already plugged your VCR 1 (VCR connected to the VCR 1 jacks), DVD player, TV, and this
receiver into the AC outlets, unplug their AC power cords first.
2. Connect the IR signal transmitter (supplied) to the IR OUT on the rear, and place it so that it is aimed at
the remote sensor on the target video components.
• See "CONNECTIONS 1" below.
3. Connect your VCR 1, DVD player, TV, and this receiver as follows, using the cables with the monaural
mini-plugs (not supplied).
• See "CONNECTIONS 2" below.
4. Connect the audio input/output jacks on VCR 1, DVD player, TV, and this receiver using the cables with
RCA pin plug.
• See pages 7 and 8.
5. Connect the video input/output jacks on VCR 1, DVD player, TV, and this receiver, using the cables with
RCA pin plugs or with S-video plugs.
• See "CONNECTIONS 3" on the next page.
6. Plug the AC power cords of the components into the AC outlets.
7. When turning on the TV for the first time after the AV COMPU LINK connection, turn the TV volume to
the minimum using the TV volume control on the TV.
8. Turn on the other connected components first, then turn on this receiver.
• When turning on the VCR 1, use the remote control supplied with this receiver (press VCR 1 POWER).
CONNECTIONS 1:
CONNECTIONS 2:
VCR 1
VHS
AV
COMPU LINK
IMPORTANT:
Connect to the terminal indicated in the
illustration.
DO NOT connect to the TV terminal.
54
On the rear panel
RF REMOTE
ANTENNA
IR OUT
At an angle of
approx. 60°
DVD player
DVD
AV
COMPU LINK
AV
COMPU LINK
Target video component(s)
IR signal transmitter
TV
If the AV COMPU LINK terminal
on the TV is "RECEIVER/AMP"
AV
COMPU LINK
RECEIVER/AMP
RECEIVER/
EX AMP
(VCR)
If the AV COMPU LINK terminal
on the TV is "AV COMPU LINK
EX"
AV
COMPU LINK EX
CAUTION:
The AV COMPU LINK remote
control system cannot control the
DBS tuner connected to the TV
SOUND/DBS jacks, and video
components connected to the
VIDEO and CDR/VCR 2 jacks on
the receiver.
Notes:
• When connecting only the
VCR 1 or DVD player to this
receiver, connect it directly to
the receiver using cable with
the monaural mini-plugs.
• Refer also to the manual
supplied with your video
components.