Optional Wall Switch Or Thermostat Installation - Travis Industries GreenSmart 564 SS Installation Manual

20

Optional Wall Switch or Thermostat Installation

Do not connect 110-240 VAC to the gas control valve or wiring system of this fireplace. The switch
must be installed by a qualified installer.
This fireplace includes an optional wall switch (with wire)
to operate the fireplace burner without accessing the
internal on/off switch. A thermostat may be used instead.
Route the wire from inside the fireplace, through the
grommet on either side of the fireplace near the gas inlet
(see at right) to the switch. The wall switch (or thermostat)
may bypass the fireplace on/off switch or be installed in
parallel or series configuration (see below).
Caution: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause
improper and dangerous operation.
Note: When using a GreenSmart™ remote, use the
receiver for on/off operation (do not use a wall
switch or thermostat).
Warning: Make sure all wiring is secure and does not
contact hot or moving components.
Parallel Connection
Thermostat / External
Switch ON
Thermostat / External
Switch OFF
To wire the heater in parallel, follow the directions below:
a
On / Off Switch
c
Travis Industries
Installation
On / Off Switch On / Off Switch
ON OFF
Heater is ON Heater is ON
Heater is ON Heater is OFF
b
Thermostat
(or External Switch) Wires
(for qualified installers only)
OPTIONAL WALL SWITCH
(included with fireplace)
Place "WARNING"
label on switch cover.
Series Connection
Thermostat /
External Switch ON
Thermostat /
External Switch OFF
To wire the heater in series, follow the directions below:
a
On / Off Switch
4090709
On / Off Switch
ON
Heater is ON
Heater is OFF
b
(or External Switch) Wires
c
On / Off Switch
OFF
Heater is OFF
Heater is OFF
Thermostat
100-01222_000