Using Recording Timer - JVC MX-GT90 Instructions Manual

Using Recording Timer

With Recording Timer, you can make a tape of a radio
broadcast automatically. You can set the timer whether the
system is on or off.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified
station, sets the volume level to "MIN," and starts recording
when the on-time comes (the
the on-time, and continues flashing while the timer is
operating). Then, when the off-time comes ("OFF" appears
just before the off-time), the unit automatically turns off (on
standby).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• To correct a mis-entry while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER repeatedly
until "REC" appears on the
display.
The REC (Recording Timer) indicator also
starts flashing on the display.
• Each time you press the button, the timer setting modes
change as follows:
DAILY ON TIME
Clock
Canceled
setting
(See page 9.)
3
Press CLOCK/TIMER again.
"ON TIME" appears for 2 seconds, then the
unit enters on-time setting mode.
indicator flashes just before
REC
ON TIME
– 23 –
4
Set the on-time you want the
unit to turn on at.
1) Turn 4 / ¢ to set the hour,
then press SET/DISPLAY.
2) Turn 4 / ¢ to set the minute,
then press SET/DISPLAY.
"OFF TIME" appears for 2
seconds, then the unit enters off-
time setting mode.
5
Set the off-time you want the
unit to turn off (on standby) at.
1) Turn 4 / ¢ to set the hour, then press
SET/DISPLAY.
2) Turn 4 / ¢ to set the minute, then press
SET/DISPLAY.
The unit enters preset station selecting mode.
6
Select the preset station.
1) Turn 4 / ¢ to select the band ("TUNER FM" or
"TUNER AM"), then press SET/DISPLAY.
2) Turn 4 / ¢ to select a preset channel number,
then press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing
and remains lit. The settings you have done are shown
on the display in sequence.
7
Press STANDBY/ON
turn off the unit (on standby)
if necessary.
If you want to listen to another source while recording
Press REC START/STOP or 7 to stop recording. Without stopping
it, you cannot change the source.
Even if you unplug the AC power cord or if a power
failure occurs
Once you set the timer, the timer setting may remain stored in
memory in a few days. In this case, check whether the timer setting
still remains or not.
to
STANDBY/ON
STANDBY