Common Operations; Turning On Or Off The Power; Setting The Clock; Selecting The Sources - JVC MX-GT90 Instructions Manual

Common Operations

Turning On or Off the Power

To turn on the unit, press
STANDBY/ON so that the
STANDBY lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
STANDBY lamp lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "AM 12:00" right away, while the tuner preset
stations (see page 12) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit.
You can set the clock whether the unit is on or off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Turn 4 / ¢ to adjust
the hour, then press
SET/DISPLAY.
The minute digits start flashing on the
display.
If you want to correct the
hour after pressing
SET/DISPLAY, press
CANCEL/DEMO. The hour
digits start flashing again.
3
Turn 4 / ¢ to adjust the minute, then
press SET/DISPLAY.
STANDBY/ON
STANDBY
To check the clock time
STANDBY/ON
Press and hold SET/DISPLAY while playing any source.
STANDBY
• Each time you press and hold the button, the source
indication and the clock time alternate on the display.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
The clock loses the setting and is reset to "AM 12:00." You need to
set the clock again.

Selecting the Sources

To listen to the FM/AM broadcasts, press FM/AM. (See
page 12.)
To play back CDs, press CD 3¥8. (See pages 13 – 16.)
To play back tapes, press TAPE 2 3. (See page 17.)
To select the external equipment as the source, press AUX.
When you press the play button for a particular source
(FM/AM, CD 3/8, TAPE 2 3, and AUX), the unit turns on
(and the unit starts playing the source if it is ready —
COMPU PLAY CONTROL).
All the audio level indicators light up when no signals come in.
– 9 –
DAILY ON TIME
Clock
Canceled
ON TIME
setting
(The hour digits start flashing.)
When you unplug the AC power cord or if a power
failure occurs
About the audio level indicator
REC