Common Operations; Setting The Clock - JVC MX-J300 Service Manual

Common Operations

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit.
For MX-J300 only
Press PANEL OPEN/CLOSE .
The unit is turned on and the Powered
Rolling Panel opens automatically.
On the unit:
1
Press CLOCK/TIMER.
BASS
SOUND MODE
The hour digits start flashing on the display.
Press 4 or ¢ to adjust the
2
hour, then press SET.
BASS
SOUND MODE
• If you want to correct the hour after pressing
SET, press CANCEL. The hour digits start
flashing again.
Press 4 or ¢ to adjust the
3
minute, then press SET.
BASS
SOUND MODE
On the remote control:
1
Press SHIFT.
2
Press CLOCK.
BASS
SOUND MODE
The hour digits start flashing on the display.
2
PANEL OPEN / CLOSE
3
CLOCK/TIMER
ST
REC
To check the clock time
Press DISPLAY while playing any source.
– +
PRESET
• Each time you press the button, the source
To adjust the clock again
ST
REC
If you have adjusted the clock before, you need to press
SET
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting
– +
PRESET
ST
REC
SET
The clock loses the setting and is reset to "AM 12:00." You need to
set the clock again.
SHIFT
CLOCK
1
ST
REC
– 11 –
Press SELECT – or + to adjust the
hour, then press SET.
BASS
SOUND MODE
• If you want to correct the hour after pressing
SET, press CANCEL (on the unit). The hour
digits start flashing again.
Press SELECT – or + to adjust the
minute, then press SET.
BASS
SOUND MODE
indication and the clock time alternate on the
display.
modes change as follows:
DAILY ON TIME
Clock
Canceled
setting
(The hour digits start flashing.)
If there is a power failure
+
– SELECT
4 5
ST
REC
SET
8
– SELECT +
4
5
ST
SET
REC
8
DISPLAY
REC
ON TIME