Dodge 1997 Neon WIRING DIAGRAMS Owner's Manual page 104

PL
DESCRIPTION AND OPERATION (Continued)
RIGHT AND LEFT TURN SIGNAL INDICATORS
These lamps are used to indicate to the operator
which turn signal is ON. Power for the lamps comes
from the turn signal switch. The L60 circuit is for the
right turn indicator, and the L61 circuit is used for
the left turn signal indicator. Ground for the circuits
is provided on the Z3 circuit.
BRAKE WARNING INDICATOR LAMP
The Brake Warning Indicator lamp is used to alert
the operator of a problem with the vehicles braking
system. The lamp illuminates when the ignition
switch is turned to START position to perform a self
check.
There are two switches used in this system and
they are wired in parallel form. A parking brake
switch located on the parking brake mechanism will
illuminate the lamp if the normally OPEN switch is
CLOSED. This switch is case grounded.
The other switch used is the brake warning lamp
switch. This switch is normally OPEN. When the
8W - 40 INSTRUMENT CLUSTER
brake system pressure is below a predetermined level
the switch CLOSES and completes a path to ground
from the G9 circuit at the cluster, through the
switch, to the left headlamp ground.
ANTI-LOCK WARNING LAMP
The Anti-Lock warning lamp is used to alert the
driver of a problem in the ABS system. When the
ABS controller determines a problem in the system it
grounds the G19 circuit and illuminates the lamp.
HELPFUL INFORMATION
• Check the 5 amp fuse in cavity 11 of the fuse
block.
• Check the 4 amp fuse in cavity 12 of the fuse
block.
• Check the Ignition-Off Draw fuse in the PDC.
• Check for a good ground at the instrument panel
left center support.
• For additional diagnostic tests refer to the
appropriate section of the Service Manual.
8W - 40 - 9