Finding A Station - Chevrolet 2008 Corvette Owner's Manual

If your vehicle has the Bose
® ®
Bose AudioPilot noise compensation technology.
When turned on, AudioPilot
the audio system equalization to compensate for
background noise, so that the music always sounds the
same at the set volume level. This feature is most
effective at lower radio volume settings where
background noise can affect how well you hear the
music being played. At higher volume settings, where
the music is much louder than the background noise,
there could be little or no adjustments by AudioPilot
®
To use AudioPilot , set the radio volume to the desired
®
level. Turn AudioPilot on by pressing the automatic
volume button until AVOL ON displays. As the
vehicle goes faster, the background noise increases.
®
AudioPilot adjusts the audio system's equalization
to overcome background noise. To turn AudioPilot
press the automatic volume button until AVOL OFF
displays. For additional information on AudioPilot
visit www.bose.com/audiopilot.
MUTE: Press to silence the system. Press again to
turn the sound on.
This button is not available on the Radio with
Six-Disc CD.
®
sound system, it includes
®
continuously adjusts
®
®
,

Finding a Station

BAND: Press to switch between AM, XM1 or XM2
(if equipped), FM1, or FM2. The display shows
the selection.
O
/ e (Tune): Turn to select radio stations.
t u
SEEK : Press the arrows to go to the previous or
to the next station and stay there.
®
.
The radio only seeks stations with a strong signal that
are in the selected band.
t u
SCAN : Press and hold either arrow for
two seconds until FREQUENCY SCAN displays.
The radio goes to a station, plays for a few seconds,
then goes on to the next station. Press either arrow
off,
again to stop scanning.
To scan preset stations, press and hold either arrow for
four seconds until PRESET SCAN displays. The radio
goes to the next preset station, plays for a few seconds,
then goes to the next preset station. Press either arrow
again or one of the pushbuttons to stop scanning
presets.
The radio only scans stations with a strong signal that
are in the selected band.
3-87