Music Scan; To Find The Beginning Of The Current Selection; To Find The Beginning Of The Next Selection; Other Useful Features Of The Cassette Deck - JVC GVT0001-002A Instructions Manual

Music Scan

To find the beginning of a music track during play, use the Music Scan function. Music Scan
searches for blank portions that usually separate selections, then plays the next selection.
To Find the Beginning of the Current Selection —————————————
Press the 1 or ¡ button during play.
To Find the Beginning of the Next Selection ——————————————
Press the 1 or ¡ button during play.
Music Scan works by detecting a 4-second long blank at the beginning of each selection, so it
won't work well if your tape has:

Other Useful Features of the Cassette Deck

REVERSE
MODE
DOLBY B
NR
Dolby noise reduction manufactured under license from Dolby Laboratories Licensing
Corporation.
"DOLBY" and the double-D symbol are trademarks of Dolby Laboratories Licensing
Corporation.
Make sure that you press the 1 or ¡ button in the opposite direction to that in which the
tape is playing. Searching stops at the beginning of the current selection, and the current
selection starts automatically.
Make sure that you press the 1 or ¡ button in the same direction as that in which the tape is
playing. Searching stops at the beginning of the next selection, and the next selection starts
automatically.
• No blank at the beginning of a selection .
• Noise (often caused by much use or poor quality dubbing) which fills the blank with noise.
• Long, very soft passages or pauses in a selection. The scan will detect these as 4-second
long blanks. If this happens, just scan again until you reach the selection you want.
Use Reverse Mode to make the tape automatically reverse at the end of a side and start playing
the other side. Press the REVERSE MODE button to change from Reverse Mode on to Reverse
Mode off, or from off to on.
Reverse Mode ON
Continuous Play: With the Reverse Mode indicator on, when tape playback in the 2 direction
finishes, the Unit always checks to see if a tape is in the other deck. If there is, it automatically
starts playing. This Continuous Play function works regardless of which deck starts first.
Press the DOLBY B NR button to switch Dolby B Noise Reduction on (the indicator lights up)
or off (the indicator goes off). If a tape is recorded with the Dolby B NR system, playing it back
with the Dolby NR on will reduce tape noise and improve the clarity of the sound.
Reverse Mode OFF
23