Preparation; Connecting The Antennas - JVC EX-A3 Instructions Manual

Preparation

Connecting the antennas

AM loop antenna (supplied)
Setting up the AM loop antenna
If insulation covers the tips of the
antenna cable, twist and pull off
the insulation.
Connecting the AM loop antenna
Main unit (rear view)
Turn the AM loop antenna to find the best position
for radio reception.
NOTE
• Make sure that the antenna conductors do not
touch any other terminals. This could cause poor
reception.
7
Do not turn on the power until you complete the connection.
FM antenna (supplied)
Main unit (rear view)
When radio reception with the supplied FM
antenna is poor, or when using a communal
antenna
Main unit (rear view)
Antenna cable
(not supplied)
Converter (not sup-
plied: compatible
with 300 C/75 C)
Depending on the radio reception
conditions, an FM feeder antenna
(not supplied: compatible with
300 C) can be used. In this case,
a converter (not supplied) is
required.
When using an antenna other than those supplied
with this system, refer to the operation manuals for
the antenna and converter for details of connec-
tion.
When positioning the antennas, find the best posi-
tion for reception while listening to an actual radio
program (refer to "Listening to radio broadcasts"
on page 19).
FM antenna
Stretch out the FM antenna
to the best position for
radio reception.
Communal
antenna terminal
or
Outdoor FM
antenna
(not supplied)
Coaxial cable
(not supplied)