Presetting Automatic Dvd Video Sound Increase Level; Changing A Playback Picture - JVC DX-T66 Instructions Manual

Presetting Automatic DVD Video
Sound Increase Level
The DVD Video sound is sometimes recorded at a lower
level than other discs and sources. You can set the increase
level for the currently loaded DVD Video, so you do not
have to adjust the volume when you change the source.
• This only functions for DVD Video disc.
Remote control:
L – BALANCE – R
DVD LEVEL
Main unit:
DVD LEVEL1
DVD LEVEL
• As the number increases, sound level also increases.
• The initial setting is "DVD LEVEL3."

Changing a Playback Picture

While viewing a playback picture on the TV, you can select
the preset picture tone, or adjust it and store your own
preference.
To select a preset picture tone
1
While playing, display VFP setting screen.
SCAN MODE
VFP
2
Select a preset picture tone.
NORMAL
Normally select this.
CINEMA
Suitable for a movie source.
USER1/USER2 You can adjust parameters and can
store the settings (see below).
15
DVD LEVEL1
DVD LEVEL2
DVD LEVEL3
DVD LEVEL2
DVD LEVEL3
Remote
ONLY
NORMAL
0
GAMMA
0
BRIGHTNESS
CONTRAST 0
0
SATURATION
TINT 0
0
SHARPNESS
On the TV screen
NORMAL CINEMA
USER2 USER1
To adjust the picture tone
1
Select "USER1" or "USER2."
• Follow steps 1 and 2 above.
2
Select a parameter you want to adjust.
GAMMA
Adjust if the neutral color is bright
or dark. The brightness of dark and
bright portions is maintained
(–3 to +3).
BRIGHTNESS Adjust if the picture is bright or dark
as a whole (–8 to +8).
CONTRAST Adjust if the far and near position is
unnatural (–7 to +7).
SATURATION Adjust if the picture is whitish or
blackish (–7 to +7).
TINT Adjust if the human skin color is
unnatural (–7 to +7).
SHARPNESS Adjust if the picture is indistinct
(–8 to +8).
3
Adjust the parameter.
4
Repeat steps 2 to 3 to adjust other parameters.
To erase the VFP screen, press VFP again.
ENTER
ENTER