JVC DX-T66 Instructions Manual page 7

~
TV/monitor
Composite video
cord (supplied)
S-Video cord
(not supplied)
Green
Component video cord (not supplied)
• To select progressive scanning mode (see page 6), use
COMPONENT jacks.
• Connect the VIDEO jack, S-VIDEO jack, or
COMPONENT jacks whichever you want to use.
Ÿ
Digital audio component
Protective cap
• Set "DIGITAL AUDIO OUTPUT" in the "AUDIO" menu
correctly according to the connected digital audio
equipment (see page 37). If the setting is incorrect, loud
noise may be generated causing damage to the speakers.
• The digital signal through the DIGITAL AUDIO OUTPUT
termunal is output only when the DVD/CD is selected as the
source.
!
Auxiliary equipment
Red
Stereo audio cord
(not supplied)
Red
Blue
O P T
I C A L
D I G I
T A L
O U T
P U T
White
⁄
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
AM loop antenna (supplied)
Turn it until the best reception is
obtained.
FM antenna (supplied)
Extend it so that you can obtain the best
reception.
For better AM/FM reception
AM loop antenna (supplied)
Keep it connected.
FM outdoor antenna
(not supplied)
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
connector (IEC or DIN45325).
• Make sure the antenna conductors do not touch any other
terminals, connecting cords or the power cord. Also, keep
the antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
Vinyl-covered wire
(not supplied)
Extend it horizontally.
Ω
wire with coaxial type
4