Flex I/O Card Port Module Srx-Ioc-16Ge-Sfp; Flex I/O Card Port Module Srx-Ioc-16Ge-Tx - Juniper SRX5600 User Manual

Flex I/O Card Port Module SRX-IOC-16GE-SFP

Description
Software release
Cables and connectors
Controls
Supported Slots
Weight
LEDs
Copyright © 2013, Juniper Networks, Inc.
You use port modules and Flex I/O Cards (Flex IOCs) to add different combinations of
small form-factor pluggable transceiver (SFP), 10-gigabit SFP transceiver (XFP), and
copper ports to your services gateway to suit the specific needs of your network. The
SRX-IOC-16GE-SFP port module
sixteen 10/100/1000 Ethernet SFP ports.
Figure 15: Flex IOC Port Module SRX-IOC-16GE-SFP
Port module with 16 Gigabit Ethernet SFP ports
Maximum throughput: 10 Gbps
Oversubscription ratio: 1.6:1
Maximum configurable MTU: 9192 bytes
Junos OS Release 9.5R1 and later
16 Gigabit Ethernet SFP ports
Button–The
ONLINE ONLINE
online and offline
Either slot in SRX5K-FPC-IOC Flex IOC
Approximately 1.6 lb (0.7 kg)
OK/FAIL LED, one bicolor:
Steady green–The port module is operating normally.
Red–The port module has failed and is not operating normally.
Off–The port module is powered down.
LINK LED, single color, one per port:
Steady green–The link is active.
Off–No link.
LED, single color, one per port:
TX/RX
Blinking Green–The port is receiving or transmitting data.
Off–No activity.

Flex I/O Card Port Module SRX-IOC-16GE-SFP

(Figure 15 on page 23) installs into a Flex IOC to add
button on the port module front panel toggles the port module
23