I/O Card Srx5K-4Xge-Xfp - Juniper SRX5600 User Manual

I/O Card SRX5K-4XGE-XFP

Description
Software release
Cables and connectors
Controls
Supported Slots
Power Requirement
Copyright © 2013, Juniper Networks, Inc.
The SRX5K-4XGE-XFP I/O card (IOC) supports four 10-Gigabit Ethernet ports (see
7 on page 15). The IOC assembly combines packet forwarding and Ethernet interfaces
on a single board, with four 10-Gbps Packet Forwarding Engines. Each Packet Forwarding
Engine consists of one I-chip for Layer 3 processing and one Layer 2 network processor.
The IOCs interface with the power supplies and Switch Control Boards (SCBs).
You must install at least one IOC in the services gateway. The IOC can be of any of the
available IOC or Flex IOC types.
You can install IOCs in any of the slots that are not reserved for Switch Control Boards
(SCBs). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the services gateway.
Figure 7: IOC SRX5K-4XGE-XFP
OK /FA IL
I/O card with four 10-Gigabit Ethernet XFP ports
Maximum configurable MTU: 9192 bytes
Junos OS Release 9.2 and later
Four 10-Gbps XFP ports
None
SRX5600–Any slot except bottom slots
SRX5800–Any slot except center slots
312 W typical, 365 W maximum
I/O Card SRX5K-4XGE-XFP
or
0 1
, , or
0 1 2/6
Figure
15