Trunk And Line Expansion - Panasonic DBS 40 Manual

Digital business system
Hide thumbs Also See for DBS 40:
Table of Contents

Advertisement

Section 300-Installation

Trunk and Line Expansion

Guidelines
l
l
Installation
1.
2.
3.
4.
5.
6.
7. Connect the 50-pin connector to CNl on the expansion connector.
DBS-70-300
The EQT'RK slot can be used for a trunk or extension card.
Different expansion connectors are used for trunks and extensions:
Expansion connector
Trunk expansion connector
Extension expansion connector
Note: With the DBS 96, the expansion connector is not required to use
the EC/TRK slot for an extension card. The DBS 96 uses connector CN14
to accommodate an extension card in the EC/TRK slot. Table 4-22 on
page 4-35 shows the pinouts from the EC/TRK slot to CN14.
Install a trunk or extension card in the slot marked EC/TRK.
Connect the appropriate expansion connector to the main cabinet with
two screws, as shown in Figure 4-18.
Connect the ground cable from the FG terminal of the expansion
connector to a screw already in use on the right side of the main cabinet.
Connect CN2 of the expansion connector to CN15 on the mother board.
Prepare a cable with a 50-pin connector on one end and wiring for the
MDF on the other end.
Cross-connect the cable to the trunks or extensions through the MDF. See
Table 4-3 "Pinouts and trunk numbers for trunk expansion connector
expansion connector CNl" on page 4-36.
DBS Manual - Issued W/95
Chapter 4. Trunks and Lines
Part No.
VB-43 120
VB-43121
4-43

Advertisement

Table of Contents
loading

Table of Contents