Panasonic KX-TVS90 Installation Manual page 237

Parameter
Prompt Mode
Authorization
for Auto
Forwarding
Mailbox
Number
Delay Time
Forwarding
Mode
COS Nos. 63 & 64 (for Managers)
Installation Manual
Value Range
(Default)
1. System When an external message is delivered, the receiver will
2. User 1 be greeted by the VPS in the specified language
3. User 2 (prompt). However, if "Selective" is enabled, then the
4. Selective receiver has a choice of prompts. See related explanation
(User 1) in "Incoming Call Service Prompt" in Table 23 in
5.3.1 Port Service Menu.
Note: When "Selective" is enabled and the receiver uses
a rotary telephone, the no-entry selection is specified by
"Prompt for Rotary Callers" in Table 23 in 5.3.1 Port
Service Menu.
1. Yes If set to "Yes", the VPS automatically forwards
2. No messages that have not been accessed for a specific
(No) length of time to another mailbox. The sub-parameters to
be set for this feature include Mailbox Number, Delay
Time, and Forwarding Mode. If set to "No", sub-
parameters cannot be assigned.
2-5 digits Specifies the mailbox to which the messages will be
(None) forwarded.
Note: The numbers of the System Group Distribution
List cannot be specified as the destination.
(h) (min) Specifies the length of time in hours and minutes that the
VPS must wait before forwarding unretrieved messages.
00:05 to 99:59
The maximum delay time is 99 h, 59 min.
(00:30)
Note: The delay time must be less than the New Message
Retention Time, or else messages will be deleted before
being forwarded.
1. Copy Specifies if forwarded messages are to be retained in the
2. Move original mailbox. When set to "Copy", copies of the
(Move) messages are retained in the original mailbox after
forwarding. When set to "Move", messages are
forwarded to the receiving mailbox and are not retained
at the original location.
SYSTEM ADMINISTRATOR'S GUIDE
Table 40
Description/Function
237