Set The Desired Room Temperature; Set The Heat Pump For Extra Hot Water - Bosch EHP 6-11 LW User And Installation Manual

Basic functions - Customer level 1

Set the desired room temperature

If you have a room sensor connected to the heat pump you can set the required
temperature in the room from the Room temperature menu. From Extra
functions (Customer level 2) you can also set how much you want the sensor to
infl uence the heating system.
This is what to do:
1. Press the Heat button in the initial menu.
2. Turn the menu dial clockwise until you reach the menu Room temperature.
Room temperature
10° 20,0
Return adjust
3. Press the Adjust button.
4. Turn the menu dial clockwise to increase the room temperature. Turn the
menu dial anti-clockwise to lower the room temperature.
5. Save the new value by pressing the Save button.

Set the heat pump for extra hot water

You can obtain extra hot water by temporarily increasing the temperature
of the water in the hot water cylinder. This may be appropriate when, for
example, a large number of people need to shower. You choose how long
the function should run using the Extra hotwater menu. . This is what to
do:
1. Press the Heat button in the initial menu.
2. Turn the menu dial clockwise until you reach the menu Extra
hotwater.3. .
Add. hot water
1h 24h
Return adjust
3. Press the Adjust button.
4. Turn the menu dial clockwise to choose the number of hours that the
electric cassette should be on (e.g. 24 hours).
Add. hot water
1h 24h
Return Save
5. Save the new value by pressing the Save button.
30°
48h
48h
The example describes how to set the
required room temperature with the
help of a connected room sensor. The
range is 10ºC to 30ºC.
When the set time has elapsed you
must repeat the setting to get extra
hot water again.
18
Note
Note