Disassembly - Suzuki DF 90 Service Manual

DISASSEMBLY

For overhauling of starting motor, it is recommended that com-
ponent parts should be cleaned thoroughly.
However, yoke assembly, armature coil, over-running clutch
assembly, magnetic switch assembly, rubber or plastic parts
should not be washed in degreasing tank or with grease dis-
solving solvent. Those parts should be cleaned with com-
pressed air and wiping with cloth.
NOTE:
Before disassembling starting motor, be sure to put match
marks at three locations (A, B and C) as shown in right figure
so that any possible component alignment mistakes can be
avoided.
1. Remove nut 1 from magnetic switch, then disconnect
connecting wire 2.
2. Remove two bolts 3 securing magnetic switch.
3. Remove magnetic switch 4 and rubber packing 5.
4. Remove screws 6, long through bolts 7 and rear cover 8.
ELECTRICAL
A A
C C
B B
4-13