JVC CA-MXDK11 Instructions Manual page 8

Auxiliary equipment
Red
Stereo audio cord
(not supplied)
For the Australian model
Stereo mini plug
(not supplied)
5
@
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
White
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• The speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the
following when installing the speakers.
–When placing the speakers near a TV set, turn off the TV's
main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV's
main power switch again.
Some TVs may still be affected even though you have
followed the above. If this happens, move the speakers away
from the TV.
Speakers
From right
speaker
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
From left
speaker