Other Settings; Setting Basic Operations - Epson EB-G6750WU Installation Manual

Setting Up

Other Settings

Setting basic operations

You can make settings for basic operations such as turning the projector on or off in Operation from the Configuration menu.
Press [Menu] button > Extended > Operation
You can make the following settings in Operation.
Operation
Turn the projector on or off by turning the main power
supply on or off or by plugging in or unplugging the
power cable.
Stop projection automatically when no image signal is
being input and no operations are carried out.
Use the projector above an altitude of 1500 m.
Start projecting images from the same source as last time
when the projector is turned on.
Control the projector from a computer using
communication commands without releasing A/V mute.
Turn off the confirmation buzzer that beeps when the
power turns on or off.
*1 Because the default is On, the projector automatically detects image signals being input when it is turned on.
*2 The default value is Any Button. A/V mute is released when any operation is performed on the projector.
Set Direct Power On to On. (Default: Off)
Set Sleep Mode to On. (Default: On) Set the time until the projector enters sleep mode in Sleep Mode Timer.
You can set within a range of 1 to 30 minutes. (Default: 30min.)
Set High Altitude Mode to On. (Default: Off)
Set Startup Source Search to Off. (Default: On)
Set A/V Mute Release to A/V Mute. (Default: Any Button)
Set Beep to Off. (Default: On)
Settings
*1
*2
31