Toshiba e-studio5560c Quick Start Manual page 16

Chapter 1 PREPARATIONS
Saving energy when not in use – energy saving modes –
This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Energy saving Procedure to switch
modes
When a specified period of
Automatic
time
Energy Save
last use of the equipment.
mode
When the [ENERGY SAVER]
button
Sleep mode when a specified period of
time
last use of the equipment.
When the [ENERGY SAVER]
button
button
Super Sleep
when a specified period of
mode
time
last use of the equipment.
*1 The default value set at the factory shipment is 1 minute.
*2 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.
*3 [ENERGY SAVER] button on the control panel.
*4 The default value set at the factory shipment is 1 minute (The default value set at the factory shipment of the European version is 20 minutes).
*5 Any of the Wireless LAN Module and e-BRIDGE ID Gate.
*6 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled, the equipment enters into the Sleep mode. For details, refer to the
following guide:
& TopAccess Guide (PDF): "Chapter 8: [Administration] Tab Page" - "[Setup] Item list"
*7 Even if you press the [Power] button, the equipment may not enter into the Super Sleep mode and the power may be turned OFF, depending on
the state of the equipment. For the conditions under which the equipment enters into the Super Sleep mode, refer to the following guide:
& TopAccess Guide (PDF): "Chapter 8: [Administration] Tab Page" - "[Setup] Item list"
*8 When a paper exit option such as the Finisher is not installed, the equipment will return to the super sleep mode immediately after print data are
output.
For changing the set period of time for entering into each mode, refer to the following guide:
& MFP Management Guide (PDF): "Chapter 2: SETTING ITEMS (ADMIN)" - "GENERAL"
For the European version
Contact your service representative to change the default settings noted above.
When the set period of time for switching to the Automatic Energy Save mode is the same as that for the Sleep mode or
the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.
If an original is placed on the original glass during the energy saving mode, its size will not be detected even when the equipment
is recovered from this mode. After pressing the [START] or [POWER] button to recover from the mode, such as when "READY" is
displayed on the basic copying function menu, place it on the glass again.
14
Conditions to enter into
modes
has passed since the
*1
When a particular option
is pressed or is installed or when a
*3
particular protocol
has passed since the enabled.
*4
When a particular option
or the [POWER] is not installed and also
*3
is pressed or when a particular protocol
*7
is disabled.
has passed since the
*4
Status of equipment
the mode
"Saving energy - press
START button. " appears on
—
the touch panel.
The touch panel display
*5
goes off and the [ENERGY
*6 is SAVER] button lights in
green.
Only the MAIN POWER
*5
lamp (red) lights.
*6
Conditions to recover
from the mode
When a button on the
control panel is pressed
*2
or when print data or fax
data are received.
Same as the Automatic
Energy Save mode.
When the [POWER] button
is pressed, when print
data or fax data are
*8
received through a wired
LAN or when the time set
for Scheduled Print has
come.