Subaru Legacy 2001 Service Manual page 48

Engine (DIAGNOSTICS)
8. READ CURRENT DATA FOR AT.
1) On the Main Menu
2) On the System Selection Menu
the [YES] key.
3) Press the [YES] key after displayed the information of transmission type.
4) On the Transmission Diagnosis
the [YES] key.
5) On the Data Display Menu
6) Using the scroll key, move the display screen up or down until the desired data is shown.
¼ A list of the support data is shown in the following table.
Battery voltage
Rear vehicle speed sensor signal
Front vehicle speed sensor signal
Engine speed signal
Automatic transmission fluid temperature signal
Throttle position signal
Gear position
Line pressure control duty ratio
Lock up clutch control duty ratio
Transfer clutch control duty ratio
Power supply for throttle position sensor
Torque converter turbine speed signal
2-4 brake timing pressure control duty ratio
Intake manifold pressure sensor voltage
2 wheel drive switch signal
Stop lamp switch signal
Anti lock brake system signal
Cruise control system signal
Neutral/Parking range signal
Reverse range signal
Drive range signal
3rd range signal
2nd range signal
1st range signal
Shift control solenoid A
Shift control solenoid B
Torque control output signal #1
Torque control output signal #2
Torque control cut signal
2-4 brake timing control solenoid valve
Low clutch timing control solenoid valve
Automatic transmission diagnosis indicator lamp
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
SUBARU SELECT MONITOR
S048503A1612
display screen, select the {Each System Check} and press the [YES] key.
display screen, select the {Transmission Control System} and press
display screen, select the {Current Data Display & Save} and press
display screen, select the {Data Display} and press the [YES] key.
Contents
EN(H6)-46
Display
Battery Voltage
Vehicle Speed #1
Vehicle Speed #2
Engine Speed
ATF Temp.
Throttle Sensor Voltage
Gear Position
Line Pressure Duty Ratio
Lock Up Duty Ratio
Transfer Duty Ratio
Throttle Sensor Power
AT Turbine Speed
2-4B Duty Ratio
Mani. Pressure Voltage
2WD Switch
Stop Lamp Switch
ABS Signal
Cruise Control Signal
N/P Range Signal
R Range Signal
D Range Signal
3rd Range Signal
2nd Range Signal
1st Range Signal
Shift Solenoid #1
Shift Solenoid #2
Torque Control Signal #1
Torque Control Signal #2
Torque Control Cut Sig.
2-4 Brake Timing Sol.
Low Clutch Timing Sol.
AT Diagnosis Lamp
Unit of measure
V
km/h or MPH
km/h or MPH
rpm
°C or °F
V
—
%
%
%
V
rpm
%
V
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF