Operating Other Manufacturers' Video Equipment - JVC RX-7520VBK Instructions Manual

Operating Other Manufacturers' Video Equipment

By changing the transmittable signals, you can use the remote
control supplied for this unit to operate other manufacturers'
equipment.
• Refer also to the manuals supplied for the other products.
• To operate these components with the remote control, first you
need to set the manufacturers' code each for TV, CATV converter,
VCR and DVD player.
• After replacing batteries of the remote control, set the
manufacturers' codes again.
To change the transmittable signals
for operating a TV
1 Set TV/CATV selector to TV.
2 Press and hold STANDBY/ON
3 Press TV SOUND.
4 Enter manufacturer's codes using buttons 1 – 9,
and 0.
5 Release STANDBY/ON
Now, you can perform the following operations on the TV.
STANDBY/ON TV/CATV
: Turn on or off the TV.
TV/VIDEO : Set the input mode (either TV or VIDEO).
TV VOLUME +/–
: Adjust the volume.
TV/CATV CH +/– : Change the channels.
After pressing TV SOUND (source selecting button), you can
use the following buttons on the TV:
1 – 10, +10 (100+) : Select a channel. +10 (100+) button will
function as the ENTER button if your
equipment requires pressing ENTER after
selecting a channel number.
Note:
Refer also to the manual supplied with your TV.
6 Try to operate your TV by pressing
STANDBY/ON TV/CATV.
When your TV turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of TV,
try each one until the correct one is entered.
TV/CATV.
TV/CATV.
Manufacturers' codes for TV
Manufacturer
JVC
Hitachi
Magnavox
Mitsubishi
Panasonic
RCA
Samsung
Sanyo
Sharp
Sony
Toshiba
Zenith
* "01" is the initial setting.
To change the transmittable signals for
operating a CATV converter
1 Set TV/CATV selector to CATV.
2 Press and hold STANDBY/ON
3 Press TV SOUND.
4 Enter manufacturer's codes using buttons 1 – 9,
and 0.
5 Release STANDBY/ON
Now, you can perform the following operations on the CATV
converter.
STANDBY/ON TV/CATV
: Turn on or off the CATV converter.
TV/CATV CH +/– : Change the channels.
After pressing TV SOUND (source selecting button), you can
use the following buttons on the CATV converter:
1 – 10, +10 (100+) : Select a channel. +10 (100+) button will
function as the ENTER button if your
equipment requires pressing ENTER after
selecting a channel number.
Note:
Refer also to the manual supplied with your CATV converter.
TO BE CONTINUED TO THE NEXT PAGE
Codes
01*
10
02
03
04, 11
05
12
13
06
07
08
09
TV/CATV.
TV/CATV.
37