JVC RX-7520VBK Instructions Manual page 16

Basic adjustment auto memory
This receiver memorizes sound settings for each source when—:
• turning off the power,
• changing the source, and
• assigning the source name.
When you change the source, the memorized settings for the
newly selected source are automatically recalled.
The following can be stored for each source:
• Input attenuator mode (see page 19)
• Balance (see page 19)
• Tone adjustment (see page 20)
• Subwoofer output level (see page 20)
• Surround mode selection (see pages 26 – 29)
• Bass boost (see page 20)
Notes:
• You cannot assign and store different settings for digital input
mode and analog input mode.
• If the source is FM or AM, you can assign a different setting for
each band.
For recording
You can record any source through the receiver to —:
• the cassette deck (or CD recorder) connected to the
TAPE/CDR jacks, and
• the VCR connected to the VCR jacks at the same time.
While recording, you can listen to the selected sound source at
whatever sound level you like without affecting the sound levels
of the recording.
Note:
The output volume level, bass boost (see page 20), tone
adjustment (see page 20), and Surround modes (see page 23)
cannot affect the recording.
Signal and speaker indicators on the display
Signal indicators
L C R
SPK
ANALOG
L C
DIGITAL AUTO
LINEAR PCM S.WFR
S.WFR LFE DIGITAL LS
LS S RS
The following signal indicators light up—:
L : •When digital input is selected: Lights up when the left
channel signal comes in.
• When analog input is selected: Always lights up.
R : • When digital input is selected: Lights up when the right
channel signal comes in.
• When analog input is selected: Always lights up.
C : When the center channel signal comes in.
LS : When the left rear channel signal comes in.
RS : When the right rear channel signal comes in.
S : When the monaural rear channel signal or 2 ch Dolby
Surround encoded signal comes in.
LFE: When the LFE channel signal comes in.
The speaker indicators light up when—:
• The corresponding speaker is activated, and
• The corresponding speaker is required for the current playback.
Notes:
• When you select "DVD MULTI," all the signal indicators except
"S" light up.
• When "SUBWOOFER" is set to "YES" (see page 16),
lights up.
Speaker indicators
1 2
L C R
R PRO LOGIC ΙΙ
LFE
S RS
S.WFR LFE
CH-
LS S RS
S.WFR
13