Connecting The Power Cord - JVC RX-7520VBK Instructions Manual

Digital connections
This receiver is equipped with two DIGITAL IN terminals—one
digital coaxial terminal and one digital optical terminal.
You can connect any digital component to one of the digital
terminals using a digital coaxial cable (not supplied).
IMPORTANT:
• When connecting the DVD player or digital TV using the digital
terminals, you also need to connect it to the video jack on the rear.
Without connecting it to the video jack, you can view no playback
picture.
• After connecting the components using the DIGITAL IN terminals,
set the following correctly if necessary:
– Set the digital input (DIGITAL IN) terminal setting correctly. For
details, see "Setting the Digital Input (DIGITAL IN) Terminals" on
page 14.
– Select the digital input mode correctly. For details, see "Selecting
the Analog or Digital Input Mode" on page 14.
Digital input terminals
Digital TV
CD player
Digital coaxial cable (not supplied)
between digital coaxial terminals
Digital optical cable (not supplied)
between digital optical terminals
When the component has a digital coaxial
output terminal, connect it to the DIGITAL 1
(DVD) terminal with the digital coaxial cable
(not supplied).
When the component has a digital optical
output terminal, connect it to the DIGITAL 2
(CD) terminal, using the digital optical cable
(not supplied).
Before connecting a digital
optical cable, unplug the
protective plug.
Notes:
• When shipped from the factory, the DIGITAL IN terminals have
been set for use with the following components:
– DIGITAL 1 (coaxial): For DVD player
– DIGITAL 2 (optical): For CD player
• When you want to operate the CD player or CD recorder using the
COMPU LINK remote control system, connect the target
component also as described in "Analog connections" (see pages 6
and 7).
• When you want to operate the DVD player using the AV COMPU
LINK remote control system, connect the DVD player also as
described in "Analog connections" (see page 8).

Connecting the Power Cord

Before plugging the receiver into an AC outlet, make sure that all
connections have been made.
Plug the power cord into an AC outlet.
DVD player
DVD
CD recorder
Keep the power cord away from the connecting cables and the
antenna. The power cord may cause noise or screen interference. We
recommend that you use a coaxial cable to connect the antenna,
since it is well-shielded against interference.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When unplugging
the cord, always grasp the plug so as not to damage the cord.
DIGITAL 1
(DVD)
DIGITAL 2 ( CD )
DIGITAL IN
9