2B-18 Front Suspension:
Front Suspension Frame, Stabilizer Bar and/or
Bushings Removal and Installation
Removal
1) Hoist vehicle and remove wheels (right & left).
2) Remove engine under cover.
3) Remove suspension control arm referring to
"Suspension Control Arm Removal and Installation:
".
4) Remove right side and left side front drive shaft
assembly referring to "Front Drive Shaft Assembly
Removal and Installation: Front in Section 3A".
5) Remove stabilizer joints (1). When loosening joint
nut, hold stud with hexagon wrench.
1
6) Disconnect front fender lining clip (1) (if equipped
with head light auto leveling system).
S5JB0A2206015
1
I5JB0A220041-01
1
I5JB0A220042-01
7) Disconnect front height sensor connector (1) (if
equipped with head light auto leveling system) and
then detach clip (2).
1
8) Disconnect steering lower shaft from pinion shaft
referring to "P/S Gear Case Assembly Removal and
Installation: in Section 6C".
9) Detach low pressure return hose (2) from low
pressure return pipe (3) and then disconnect pipe
bracket (1).
1
3
10) Remove gear box union bolt (1).
1
2
I5JB0A220043-01
2
I5JB0A220044-01
I5JB0A220045-01