Panasonic KX-NCP500 Programming Manual page 662

5.22 [3-8-1] VM(DTMF) Group—System Settings
Others—Call Waiting on VM Group
Enables the queuing of calls when all extension ports of the VM (DTMF) group are busy. (Call Waiting tone is
not sent to any VM port.)
Value Range
Disable, Enable
Maintenance Console Location
5.22 [3-8-1] VM(DTMF) Group—System Settings
Programming Manual References
None
Feature Guide References
1.2.2.4 Queuing Feature
Others—FWD to the VPS Sequence
Specifies which DTMF commands the VPS receives from the PBX when a call is forwarded to the VPS, so
that the VPS can answer the call either with a mailbox or in the AA service mode. It is also possible to send
no DTMF signal to the VPS.
Value Range
None, Answer by Mailbox, AA
Maintenance Console Location
5.22 [3-8-1] VM(DTMF) Group—System Settings
Programming Manual References
None
Feature Guide References
None
Others—Intercept Routing to the VPS Sequence
Specifies which DTMF commands the VPS receives from the PBX when a call is intercepted to the VPS, so
that the VPS can answer the call either with a mailbox or in the AA service mode. It is also possible to send
no DTMF signal to the VPS.
Value Range
None, Answer by Mailbox, AA
Maintenance Console Location
5.22 [3-8-1] VM(DTMF) Group—System Settings
662 PC Programming Manual