Using The Spool Stand - Brother 882-W20/W22 Operation Manual

h
Continue threading however do not pass
the thread in the needle bar thread guide
"6" on the needle bar. Thread the needle on
the right side.
a Needle bar thread guide
i
Press to unlock all keys and buttons.
j
Select a stitch pattern. (Example:
* Refer to "Sewing a Stitch" on page 82 for selecting
the stitch.
* Refer to the "STITCH SETTING CHART" at the end
of this manual for the proper stitch to use with
presser foot "J".
→ The selected stitch is displayed.
Note
• If the key is light gray after selecting
the stitch, the selected stitch cannot be
sewn in the twin needle mode.
k
Press to select the twin needle mode.
a
a Single needle/twin needle setting
→
appears.
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
l
Start sewing.
Sample of Twin Needle Sewing
)
Memo
• To change direction when sewing with the
twin needle, raise the needle from the
fabric, raise the presser foot lever, and then
turn the fabric.

Using the Spool Stand

The included spool stand is useful when using
thread on spools with a large diameter (cross-
wound thread). This spool stand can hold two
spools of thread.
Memo
• See page 24 to assemble the spool stand.
• See page 58 to wind the bobbin when using
the spool stand.

■ Using the Spool Stand

• Be sure to use a spool cap that is slightly larger
than the spool.
If the spool cap that is used is smaller or much
larger than the spool, the thread may catch and
sewing performance may suffer.
UPPER THREADING
CAUTION
1
67