Brother 882-W20/W22 Operation Manual page 27

CAUTION
• Do not lift the handle of the machine while the
spool stand is installed.
• Do not push or pull the telescopic thread
guide or spool pins with extreme force,
otherwise damage may result.
• Do not place any object other than spools of
thread on the spool support.
• Do not try to wind thread on the bobbin while
sewing using the spool stand.
■ How to assemble the spool stand
a
Fully extend the telescopic thread guide
shaft, and then rotate the shaft until the two
internal stoppers click into place.
b
Insert the telescopic thread guide into the
round hole at the center of the spool
support, and then use a screwdriver to
securely tighten the screw (a) from the
reverse side.
a Screw
NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
Note
• Make sure that the stoppers on the
telescopic thread guide shaft are firmly in
place and that the thread guide openings
are directly above the two holes for spool
pins in the spool support. In addition, check
that the shaft is securely tightened in the
spool support.
c
Firmly insert the two spool pins into the two
holes in the spool support.
d
Open the upper cover of the machine, and
then pull the upper cover up to remove it
from the machine.
e
Insert the spool stand onto the notches of
the machine.
25