Changing The Position Of A Sticker - Brother 882-W20/W22 Operation Manual

→ Message appears on screen and carriage will move
after pressing
w
Lower the presser foot, and then embroider
the third pattern.
→ When embroidering is finished, the following
message appears. When finished connecting
patterns, press
→ After embroidering is finished,
located at the top left of LCD screen.
The three patterns have been connected.

Changing the Position of a Sticker

If the selected pattern or positioning stickers for
connecting the next pattern do not easily fit in the
embroidering area, follow the on-screen instructions
o
that appear after step on page 324 in order to move
the positioning stickers.
For an example, the on-screen instruction appears
when you use the embroidery frame with a size of 10
cm × 10 cm (4 inches × 4 inches) to connect patterns as
shown below.
a Pattern A
b Pattern B
.
.
is no longer
USING THE CAMERA TO CONNECT PATTERNS
a
a
Refer to steps through
"Connecting Three Patterns" using the
embroidery frame with a size of 10 cm × 10
cm (4 inches × 4 inches) to embroider the
first pattern and to connect the second
pattern.
Note
• When referring to steps
make sure you change the reference edge
and reference point to reflect this exercise.
a
a Reference point
b Reference edge
o
of
a o
through ,
7
b
327