DISASSEMBLY / REASSEMBLY INSTRUCTIONS
4.2 Disassembly
4.2.1 Case Removal
1.
Remove the battery from the back of the telephone. Remove the four case screws located inside the battery compartment.
2.
Remove the cover from the case by pulling from the connector end of the telephone. Care must be taken when separating
the case from the cover as the retaining clips may be very stiff – if necessary, re-attach the battery to provide extra support
for the case.
3.
Remove the two screws securing the PCB assembly to the case. Lift the PCB assembly away from the case.
Issue 1
Revision 0
Figure 4.1: Screw removal
Figure 4.2: Case Disassembly
Figure 4.3: PCB Assembly Removal
Section 4
– 20 –
MCUK991001C8
Service Manual