Disassembly/Reassembly Instructions; General - Panasonic G600 Service Manual

5

DISASSEMBLY/REASSEMBLY INSTRUCTIONS

5.1

General

This section provides disassembly and reassembly procedures for the main components of the G
These procedures MUST be performed by qualified service personnel, at an authorized service
The following warnings and precautions MUST be observed during ALL disassembly/reassembly op
WARNING
The equipment described in this manual contains polarised capacitors utilising liquid ele
are entirely safe provided that neither a short-circuit nor a reverse polarity connection
capacitor terminals. FAILURE TO OBSERVE THIS WARNING COULD RESULT IN DAMAGE TO THE
EQUIPMENT OR, AT WORST, POSSIBLE INJURY TO PERSONNEL RESULTING FROM ELECTRIC SHOCK
OR THE AFFECTED CAPACITOR EXPLODING. EXTREME CARE MUST BE EXERCISED AT ALL TIMES
WHEN HANDLING THESE DEVICES.
Caution
The equipment described in this manual contains electrostatic sensitive devices (ESDs). D
these devices if the appropriate handling procedure is not adhered to.
ESD Handling precautions:
A working area where ESDs may be safely handled without undue risk of damage from electrosta
must be available. The area must be equipped as follows:
Working Surfaces - All working surfaces must have a dissipative bench mat, SAFE for use with li
connected via a 1M2 resistor (usually built into the lead) to a common ground point.
Wrist Strap - A quick release skin contact device with a flexible cord, which has a built in sa
5k2 and 1M2 shall be used. The flexible cord must be attached to a dissipative earth point.
Containers - All containers and storage must be of the conductive type.
MCUK980101C8
Service Manual
DISASSEMBLY/REASSEMBLY INSTRUCTIONS
Section 5
5 - 1
tem.
s:
These devices
cross the
occur to
charge,
between
Issue 1
Revision 0