Panasonic EB-GD30 Service Manual page 40

TEST AND MEASUREMENT
c. PC
Channel box software loaded and the screen indicating as shown:
3. Press ENTER on the PC keyboard.
4. Switch on the +12 V supply.
5. At the PC press F10.
6. At the Interface box switch the power to ON.
7. Steps 5 and 6 above must be carried out within 1 second or power ON will time-out.
NOTE: The display will read:
GET STATION
ADDRESS = _ _
INFO = _ _
The back light will be illuminated and all LEDs will be lit.
Go to section 7.4 (Channel Box Test Commands) for further testing information.
Power On in Normal Mode
1. Connect together the test equipment.
Issue 1
Revision 0
Figure 6.9: PC Screen (SCRN10)
Figure 6.10: External test equipment setup
Section 6
– 34 –
MCUK991001C8
Service Manual