Setting The Time Range For Hourly Reports 2619; Programming Of Power Saving Mode 2689 - Sharp ER-A410 Instruction Manual

ER-A410/A420(SEC)-4 03.12.22 0:20 PM
Setting the time range for hourly reports
You can set the time range for the hourly report.
Procedure
.
2619
*A: Time range
To set the time range to 30 minutes (in the 24-hour system), enter 0.
To set the time range to 60 minutes (in the 24-hour system), enter 1.
BC: Starting time (hour = 00 to 23)
Example
Setting the time range to 60 minutes with the starting time being set at 7:00
Note To change this setting, an hourly Z report (#160) must be taken prior to the changes.
Programming of power saving mode
Procedure
.
2689
* Item:
A Entering power save mode when time is
displayed.
BCD Time (min.) to entering power save mode
since no operation is made.
Example
132
Page 132
When A thru C are all zeros.
a
@ @
*
ABC
Key operation
. @
2619
a
107
a
@ @
*
ABCD
Key operation
. @
2689
a
0030
2619
PGM 2
Print
2689
PGM 2
Selection:
Enable
Disable
1 through 254 (min.)
(999: The power save mode is inhibited.)
Print
Entry:
0
1