Listening To The Radio; Basic Tuner Operations - JVC CA-UXNB7DAB Instructions Manual

Listening to the Radio

Basic Tuner Operations

To
Select a band
Change the FM reception mode
(When a stereo broadcast is
hard to receive or noisy)
For FM/AM
Select a frequency
Tune in to a preset station
For DAB
Select an ensemble
Select a service (either primary
or secondary)
Tune in to a preset service
Tune in to all ensembles
9
On the System On the remote
When you change the source to DAB for the fi rst time after plugging in the
AC power cord, the System automatically scans the DAB bands for available
ensembles. (See page10.)
• For general information of DAB, see "What is DAB system?" on page 10.
—
or
—
or
—
Press
Each time you press the button, the band
changes as follows:
AM
The selected band and frequency appear on
the main display.
• When an FM stereo broadcast with
suffi cient signal strength is tuned in, the ST
(stereo) indicator lights on the display.
Press to improve reception.
The MONO indicator lights up on the display.
Reception will improve though the stereo
eff ect is lost.
To restore the stereo eff ect, press again.
Press and hold for more than 2 seconds.
The System starts searching for stations and
stops when a station of suffi cient signal
strength is tuned in.
or
• Press during searching to stop.
• Press repeatedly to change the frequency
step by step.
Press to select a preset number for the preset
station.
or
• For presetting stations, see page 12.
Press and hold for more than 2 seconds.
• You can select from the ensembles
scanned by the ensemble scanning.
or
Press briefl y while tuning in to an ensemble.
Press briefl y to select a preset number for the
preset service.
• For presetting services, see page 12.
Press and hold for more than 2 seconds.
or The frequency changes every second
through all ensembles regardless of the
signal status.
• Press and hold the button until the desired
ensemble is reached.
DAB
FM