Solving Option Problems - Lexmark X950 Series User Manual

My MFP troubleshooting
Error reading USB drive
Some flash drives may not be compatible with the printer. At a minimum, the flash drive should:
• Be USB 2.0-compatible
•
Support the Full Speed standard (low-speed devices will not work)
•
Have a USB type "A" connector
•
Support the FAT file system (NTFS file system not supported)
For a list of tested and approved flash drives, visit the Lexmark Web site at www.lexmark.com.
Nothing happens when USB drive is inserted
If nothing happens within a few seconds after you insert your USB drive into the MFP, then use of USB drives may be
disabled on the device. Contact your system support person for more information.
I forgot the password to My MFP
If you forget the password for your My MFP profile, then you must delete the profile from your USB drive, insert the
drive into an MFP, and then run the setup wizard again. To manually delete the My MFP profile from your USB drive:
1
Insert your USB drive into a computer.
2
Locate the .mymfp.preferences file, as well as any other files beginning with .mymfp (they will be grouped together).
3
Delete all files beginning with .mymfp.

Solving option problems

Option does not operate correctly or quits after it is installed
Try one or more of the following:
R
ESET THE PRINTER
Turn the printer off, wait for about 10 seconds, and then turn the printer on.
C
HECK TO SEE IF THE OPTION IS CONNECTED TO THE PRINTER
1
Turn the printer off using the power switch.
2
Unplug the power cord from the wall outlet, and then from the printer.
3
Check the connection between the option and the printer.
Troubleshooting
313