KVH Industries TracVision TV1 Installation Manual page 29

16 Continued
Linear Receiver Setup for Automatic
Switching
For automatic switching to work properly using
the DiSEqC communications protocol, set up the
linear receiver for the same satellites installed in
the TracVision system. Set up the satellites in the
receiver in the exact same order as they were set
up in the antenna. The specific setup process
varies among receiver models – refer to the
receiver's manual for details. Use the table below
and Figure 46 as a guide.
Satellites Matching Satellites
in Antenna in Receiver
Slot A Port/Switch/LNB/DiSEqC 1 or A
Slot B Port/Switch/LNB/DiSEqC 2 or B
Slot C Port/Switch/LNB/DiSEqC 3 or C
Slot D Port/Switch/LNB/DiSEqC 4 or D
28
Set Up the System
Figure 46: Linear Receiver DiSEqC Settings (Example)