Ricoh Pro C651 EX Operating Instructions Manual page 97

• Before loading envelopes, place them on a flat table or desk and press down on them to release
excess air and flatten them out. When loading envelopes, make sure they do not go over the limit
mark.
• Place one envelope at a time on the Wide LCT if you still get any of the following results:
• The envelope jams
• The envelope is not fed
• Multiple envelopes are fed at the same time
• Humidity levels of over 50% can cause envelopes to come out creased or misprinted.
• Certain types of envelopes might come out creased, dirtied, or misprinted. If you are printing a
solid color or image on an envelope, lines may appear where the overlapped edges of the
envelope make it thicker.
• If the horizontal size of the envelope is 297 mm (11.7 inches) or less, a paper misfeed might occur.
If this happens, turn off Skew Detection. For details, see "Adjustment Settings for Operators",
Network and System Settings Reference.
• When printing on envelopes thicker than 127.0 g/m
Strong or Adjust Curl: Strong for Adjust Paper Curl of Adjustment Settings for Operators.
• Keep envelopes stored in sealed plastic bags and remove only the quantity needed. Do not add
envelopes during printing, as this might cause misfeeds.
2
(47.0 lb. Cover), do not use Adjust
Envelopes
2
Curl:
95