Sony PCS-TL50 Operating Instructions Manual page 51

Video communication system
Hide thumbs Also See for PCS-TL50:
Table of Contents

Advertisement

of NAT. This option is effective only
when you use the UPnP router.
NAT Address
Enter the IP address of a global network to
be used for NAT mode.
Packet Resend Request
Selects whether or not to request to resend
the packet when a packet loss occurs during
communication.
On: Requests resending a packet.
Off: Does not request resending a packet.
Adaptive Rate Control
Sets whether or not to always optimize the
LAN bandwidth.
On: Always optimizes.
Off: Disables optimization of the LAN
bandwidth.
Note
This item is enabled only when "Packet Resend
Request" is set to "Off". When "Packet Resend
Request" is set to "On", this item is always set
to "On".
LAN Mode
Selects the interface type and the
communication mode of the LAN
connection.
Auto Negotiation: The interface type and
the communication mode are recognized
automatically.
100Mbps Full Duplex: Connects via
100BASE-TX in full duplex mode.
100Mbps Half Duplex: Connects via
100BASE-TX in half duplex mode.
10Mbps Full Duplex: Connects via
10BASE-T in full duplex mode.
10Mbps Half Duplex: Connects via
10BASE-T in half duplex mode.
Packet Loss Indicator
Selects whether or not to display the Packet
Loss indicator on the display if a packet loss
occurs on a network.
On: Displays the Packet Loss indicator on
the display if a packet loss has occurred.
Off: Does not display the Packet Loss
indicator on the display even if a packet
loss has occurred.
Page 5/11
LAN Setup
Page: 5/11
Port Number Used
TCP Port Number
UDP Port Number
Port Number Used
Selects whether or not to fix the TCP port
number and UDP port number.
Custom: Uses the port numbers set by the
user.
Default: Uses the default port numbers,
2253 for the TCP port number and
49152 for the UDP port number.
TCP Port Number
When "Port Number Used" is set to
"Custom", enter the TCP port number.
The display shows usable port numbers.
UDP Port Number
When "Port Number Used" is set to
"Custom", enter the UDP port number.
The display shows usable port numbers.
For details on the port numbers used, see
"List of Port Numbers Used on the PCS-
TL50" on page 268.
Page 6/11 to Page 9/11
LAN Setup
Page: 6/11
TOS
IP Precedence
Low Delay
High Throughput
High Reliability
Minimum Cost
Page 6/11 to Page 9/11 allow you to specify
the TOS (Type of Service) field for various
data.
The TOS field of the following data can be
specified on each page.
Registering Local Information
Default
2253 – 2263
49152 – 49239
Save
Cancel
IP Precedence
0
Off
Off
Off
Off
Save
Cancel
51

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ipela pcs-tl50

Table of Contents