Sony PCS-TL50 Operating Instructions Manual page 248

Message
A still image is being sent or received. The
Data Solution Box is not usable.
Connection with the Data Solution Box is
not correct. Please reset the system.
Fan in the Data Solution Box does not work
properly. The Data Solution Box is not
usable.
The far-end system is not compatible with
the encryption feature.
The encryption feature on a far-end system
is disabled.
The encryption feature on a far-end system
is enabled.
The entered password for the encryption
feature is not correct.
The encrypted videoconference is not
available if any terminal is connected via
ISDN.
At least thirteen characters are required as a
password for the encryption feature.
The conference could not start because the
encryption feature at the near-end side was
disabled.
The conference could not start because the
encryption feature at the far-end side was
disabled.
The standard encryption videoconference
with SIP connection is not available.
The Proprietary encryption videoconference
with ISDN connection is not available.
PPPoE connection has failed.
PPPoE server admission has failed.
Connection to the PPPoE server fails.
Communication via LAN is not available.
Check the LAN cable.
248
On Screen Messages
Meaning
While you are sending or receiving a still image,
you cannot send or receive the RGB picture via the
Data Solution Box.
Connection between the Video Communication
System and the Data Solution Box is not correct.
Turn off the Video Communication System, then
turn it on again.
The fan equipped with the Data Solution Box is
not working properly. You cannot use the Data
Solution Box.
When conducting an encrypted videoconference,
you cannot connect to the system that is not
compatible with the encryption feature.
When conducting an encrypted videoconference,
you cannot connect to the system if the encryption
feature is deactivated.
When conducting a daily conference, you cannot
connect to the system if the encryption feature is
activated.
Enter the correct password.
While the videoconference is held via the ISDN
connection, you cannot connect any terminal via
the LAN connection if your encryption feature is
set to Proprietary encryption.
You have to enter 13 to 20 characters, numerals or
symbols as the password required for conduct of an
encrypted videoconference.
Enable the encryption feature.
Have the far-end side enable their encryption
feature.
Change connection methods, or switch to SONY
encryption.
Change connection methods, or switch to standard
encryption.
LAN connection has failed. Check the PPPoE
setting.
Access to a network is not admitted by the PPPoE
server.
Check the DNS server setting.
The connection to a LAN cannot be made. Check
the LAN cable.