HYT TC-610P Service Manual page 9

TC-610P Service Manual
Description of Modes
User Mode
It is a conventional communication mode. After the radio is turned on, it enters the User Mode.
PC Programming Mode
The radio can enter PC Programming Mode through specific protocol based communication with the
programming software. In this mode, radio functions and adjustment parameters can be set through
programming software (including User Version and Factory Version).
Wired Clone Mode
1. Description
Wired Clone Mode is an independent mode. To access other modes, you must restart the radio.
Wired Clone Mode includes User Clone Mode and Factory Clone Mode.
(1) User Clone Mode:
Connect two radios using a cloning cable. Then turn on the source radio with SK2 held down, and the
radio enters User Clone Mode in 2 seconds. The target radio can be directly turned on to enter the mode.
In this mode, data stored in EEPROM of the source radio will be cloned to EEPROM of the target radio.
The data transferred only covers channel data and common parameters, excluding adjustment data,
version and serial No. of the model.
(2) Factory Clone Mode:
Short the SELF pin of the source radio MCU, and connect the two radios using a cloning cable. Then
turn on the source radio with SK2 held down, and the radio enters Factory Clone Mode in 2 seconds.
The target radio can be directly turned on to enter user mode. Data transferred covers all data in
EEPROM other than the Serial No., with the Tuning Switch flag included.
2. Process
Process of Wired Clone:
(1) Orange LED flashes once after the source radio enters Wired Clone Mode. Press SK2 again to clone
data to the target radio.
(2) During cloning, LED on the source radio flashes red, and LED on the target radio flashes green. After
cloning ends, LED of both radios will go out, indicating both radios are ready for another cloning
operation.
7