HYT TC-610P Service Manual page 85

Rotate the Channel
Selector Knob to CH5
and press PTT to enable
this function. Select the
wide band and low
frequency.
Press PTT to switch
among frequencies
(medium -low, medium,
CDCSS
medium -high and high).
Deviation
Long press PTT to enter
the narrow band and
select low frequency.
Press PTT to switch
among frequencies
(medium -low, medium,
medium -high and high).
Rotate the Channel
Selector Knob to CH6,
CH7 and CH8, and set
their CTCSS to low,
medium and high
CTCSS respectively. Press PTT
Deviation to enable this function,
and select the wide
band. Short press PTT
to switch among
frequencies on each
channel.
Rotate the Channel
Selector Knob to CH6,
CH7 and CH8, long
CTCSS
press PTT to enter the
Deviation
narrow band, and short
press PTT to switch
among frequencies.
Communication
Test Set BPF: Antenna
<20Hz~300Hz
Communication
Test Set
Antenna
BPF:
<20Hz-300Hz
Communication
Test Set
Antenna
BPF:
<20Hz-300Hz
83
TC-610P Service Manual
Adjust VR601 with
ceramic tuning tool
to check each
frequency. Enter the
Adjustment Mode if
necessary, and
press SK1 or SK2
to perform fine
tuning until the
VR
CDCSS deviation
601
meets the
SK1
requirements.
SK2
Enter the
Adjustment Mode if
necessary, and
press SK1 or SK2
to perform fine
tuning until the
CDCSS deviation
meets the
requirements.
Adjust VR601 with
ceramic tuning tool
to check each
frequency. Enter the
VR Adjustment Mode if
601 necessary, and
SK1 press SK1 or SK2
SK2 to perform fine
tuning until the
CTCSS deviation
meets the
requirements.
Enter the
Adjustment Mode if
necessary, and
VR
press SK1 or SK2
601
to perform fine
SK1
tuning until the
SK2
CDCSS deviation
meets the
requirements.
500-900Hz
(550-650Hz is
recommended)
300-500Hz
500-900Hz
(550-650Hz is
recommended)
300-500Hz