HYT TC-610P Service Manual page 5

Name of Key
SK1
SK2
Note:
Short press: key press duration is shorter than 1.5 second;
Long press: key press duration is equal to or longer than 1.5 second.
﹡LED Indicator
Status indications and alert tones are shown in the table below:
Turn on the source radio
with PTT&SK2 held down
simultaneously.
Turn on the target radio
directly.
After the target radio is
Wired
Clone turned on and the cloning
cable is connected, press
SK2 of the source radio to
begin cloning.
Target radio
Power on in User Mode
Low Battery Alert
Operation
Short press
Long press
Short press
Long press
Orange LED flahses once.
LED flashes red during cloning process;
LED goes out once the cloning succeeds;
LED goes out once the cloning fails.
LED flashes green during the cloning process;
LED goes out once cloning is completed.
When the radio is turned on, it sounds the power-on alert.
When the radio is currently on a blank channel, it sounds
beep tone continuously.
LED flashes red, and a low-pitched tone sounds every 10
seconds.
Function
None
Battery strength indication
None
Squelch Off Momentary
3
TC-610P Service Manual