Installing; Deciding On An Installation Site; Installation Space - Roland GX-640/GX-500/GX-400/GX-300 Setup Manual

1-2 Installing

Deciding On an Installation Site

Install in a stable location offering good operating conditions. An unsuitable location can cause accident,
faulty operation, or breakdown.
WARNING
WARNING
WARNING
CAUTION
CAUTION
Unsuitable Installation Sites
 Locations subject to shaking or vibration
 Locations where the floor is tilted, not level, or unstable
 Locations exposed to direct sunlight or near air-conditioning or heating equipment
 Locations within 1 m (39-3/8 in.) of strong illumination
 Dusty locations
 Locations exposed to considerable electrical or magnetic noise, or other forms of electro-
magnetic energy
 Locations with poor heat radiation

Installation Space

Be sure to ensure a sufficient amount of installation space for the machine.
Never use out of doors or in any location where exposure to water or high
humidity may occur. Never touch with wet hands.
Doing so may result in fire or electrical shock.
Never place any flammable object nearby. Never use a combustible aerosol
spray nearby. Never use in any location where gases can accumulate.
Combustion or explosion may be a danger.
Position so that the power plug is within immediate reach at all times.
This is to enable quick disconnection of the power plug in the event of an
emergency. Install the machine next to an electrical outlet. Also, provide enough
empty space to allow immediate access to the electrical outlet.
Install in a location that is level and stable.
Installation in an unsuitable location may cause an accident, including a fall
or tipover.
Unloading and emplacement are operations that must be performed by
two persons or more.
Tasks that require undue effort when performed by a small number of persons
may result in physical injury. Also, if dropped, such items may cause injury.
The material moves forward and
backward during cutting. Do not
place any objects within at least 600
mm (23-5/8 in.) from the front or rear
of the machine. Make sure that there
are no obstructions (such as a wall,
etc.) behind the machine.
19