Belkin N1 MIMO Wireless User Manual page 87

Troubleshooting
I can't connect to the Internet wirelessly, but my network name
is listed.
If.the.name.of.your.network.is.listed.in.the."Available.Networks".list,.
please.follow.the.steps.below.to.connect.wirelessly:
1.
. Click.on.the.correct.network.name.in.the."Available.
Networks".list.
2.
. If.the.network.has.security.(encryption).enabled,.you.will.need.to.
enter.the.network.key..For.more.information.regarding.security,.see.
the.section.entitled."Changing.the.Wireless. .
Security.Settings".
3.
. Within.a.few.seconds,.the.tray.icon.in.the.lower,.left-hand.corner.
of.your.screen.should.turn.green,.indication.of.a.successful.
connection.to.the.network.
I can't connect to the Internet wirelessly, and my network name
is not listed.
If.the.correct.network.name.is.not.listed.under."Available.Networks".in.
the.wireless.utility,.please.attempt.the.following.troubleshooting.steps:
1.
. Temporarily.move.computer,.if.possible,.five.to.10.feet.from.the.
Modem.Router..Close.the.wireless.utility,.and.reopen.it..If.the.
correct.network.name.now.appears.under."Available.Networks",.
you.may.have.a.range.or.interference.problem..Please.see.the.
suggestions.discussed.in.the.section.titled."Placement.of.your.N1.
Wireless.Modem.Router".of.this.User.Manual.
2.
. Using.a.computer.that.is.connected.to.the.Modem.Router.via.a.
network.cable.(as.opposed.to.wirelessly),.ensure.that."Broadcast.
SSID".is.enabled..This.setting.is.found.on.the.Modem.Router's.
wireless."Channel.and.SSID".configuration.page.
If.you.are.still.unable.to.access.the.Internet.after.completing.these.
steps,.please.contact.Belkin.Technical.Support.
85