Belkin N1 MIMO Wireless User Manual page 83

Troubleshooting
The Setup Assistant completed installation, but my web
•.
browser doesn't work.
I am unable to connect to the Internet. The "modem" LED
•.
on my Modem Router is off, and the "internet" LED is
blinking.
If.you.cannot.connect.to.the.Internet,.and.the."modem".LED.is.off,.
and.the."internet".LED.is.blinking,.the.problem.may.be.that.your.
modem.and.Modem.Router.are.not.connected.properly.
1.
.. Make.sure.the.network.cable.between.the.modem.and.the.
Modem.Router.is.connected..The.cable.should.be.connected.
at.one.end.to.the.Modem.Router's."to.Modem".port,.and.at.the.
other.end.to.the.network.port.on.your.modem.
2.
.. Unplug.the.cable.or.DSL.modem.from.its.power.source.for.
three.minutes..After.three.minutes,.plug.the.modem.back.into.its.
power.source..This.may.force.the.modem.to.properly.recognize.
the.Modem.Router.
3.
.. Unplug.the.power.to.your.Modem.Router,.wait.10.seconds,.and.
then.reconnect.the.power..This.will.cause.the.Modem.Router.to.
reattempt.communication.with.the.modem..If.the."modem".LED.
on.the.Modem.Router.is.not.lit.after.completing.these.steps,.
please.contact.Belkin.Technical.Support.
4.
.. Try.shutting.down.and.restarting.your.computer.
81